Step 1: Remove Solar Panel
- Make sure the umbrella handle is at the bottom of the pole.
- Remove the solar panel that is on top of the umbrella.
Step 2: Loosen Canopy
- Remove the ribs from the canopy pockets.
- Slide the handle up approximately 10 inches.
Step 3: Open Canopy
- Using a drill or screwdriver, remove the screw from the main pole.
- Detach the Velcro strap to open the canopy.
Step 4: Remove Canopy
- Remove the canopy from the umbrella frame.
Step 5: Place Canopy
- Flip the canopy inside out and place your arm under the canopy.
- Locate the hole on top of the canopy and pass 2 fingers through it.
- Place your fingers on top of the umbrella. Ti
- Flip the canopy over the umbrella frame.
Step 6: Close Canopy
- Close the canopy opening using the Velcro straps.
- Using a drill or screwdriver, screw the canopy to the main pole.
Step 7: Secure Canopy
- Place each rib back into the canopy pockets.
- Place the solar panel on top of the umbrella.
Step 8: Test Umbrella
- Open and close the umbrella to make sure the canopy is properly installed.
